6.1 Anonymous IPv6 at Microsoft Windows.

4.3.2 Announce your own subnet with radvd.

3.10 6to4 on WAN connections with dynamically assigned IPv4 address.

3.5 6to4 on current builds (after v24 sp1).

2.3 Configuring Radvd (if your DD-WRT box is NOT your IPv6-router).

ip6tables is NOT included by default with DD-WRT, which means your clients will be directly exposed to the Internet once you have enabled IPv6. Keep in mind it can be dangerous to enable IPv6 without also having a firewall on each client that handles IPv6 packets, or having ip6tables on your router to filter incoming connections. The next version of the TCP/IP protocol, IPv6 offers 128-bit address space, or 2 128 (≈ 3.4 x 10 38) IP addresses this is approximately 5×10 28 addresses for each of the roughly 6.5 billion people alive today, or about 57 billion addresses for each gram of matter in the Earth, or 6.67*10 23 addresses for each m² of Earth, including oceans. There are too many devices in the world for 32-bit (2 32, or 4,294,967,296) IP addresses to be sufficient. It follows IPv4 as the second version of the Internet Protocol to be formally adopted for general use. I did upgrade to the latest recommended versionĪnd it still shows unnamed network in the wireless survey.Internet Protocol version 6 ( IPv6) is a network layer IP standard used by electronic devices to exchange data across a packet-switched network. LOM: 'If you show that you have not bothered to read the forum announcements or to follow the advices in them then the level of help available for you will drop substantially, also known as Murrkf's law.' If you just want a fish, wait for a fisherman who hands them out. I'm trying to teach you to fish, not give you a fish. I am setup in bridged repeater mode also.

I have done the virtual setup with an SSID different than the main router, and it still comes up as unnamed network on the bridged router. I am using an ASUS (will have to get the model number) with V24 SP2 Mega and I have the same issue. Posted: Sun 20:30 Post subject: Same issue What firmware, and what instructions did you follow (show us a link) I suggest you start by reading the announcements at the top of this forum. The router continues to show up as unnamed.

I have matched the security settings to the primary router including matching passwords. After following instructions that I found, the router shows up as an 'Unnamed network' in my wireless network list. I have a WRT54GS v4 router that I am setting up to use as a repeater bridge. Posted: Fri 22:30 Post subject: Re: Repeater Bridge setup issue Location: Wherever the wind blows- North America

Dd wrt v24 sp2 bridge setup